Velotypo Posted February 21, 2017 Share Posted February 21, 2017 When using FP for imposition, specifically a saddle stitch job, is there a way to adjust for creep or shingling? Thanks Chris Quote Link to comment Share on other sites More sharing options...
FreightTrain Posted February 24, 2017 Share Posted February 24, 2017 No, this is not available in FP Imposer. Quote Link to comment Share on other sites More sharing options...
DSweet Posted May 26, 2021 Share Posted May 26, 2021 Has this changed over the several iterations of FusionPro and it's Imposition programming since 2017? Asking because I have to do a job that MUST be run as a saddle stitch job with a 1/4" gutter down the middle. I know that I can design each of the booklet pages with an extra 1/4" alternating along each side to accomplish that but I would like to be able to do that just in the imposition. If that spacing needs to change to 1/8" or to 3/8" or something else besides the 1/4" then the entire job has to be scrapped and started again from the artwork design phase. Quote Link to comment Share on other sites More sharing options...
Dan Korn Posted May 28, 2021 Share Posted May 28, 2021 Not much has changed regarding basic imposition functionality in that time frame, unfortunately. We do have a number of imposition enhancements on our list, but I can't say when they'll be implemented. Regarding your specific case, I'm not sure I completely understand what you're trying to do. A mock-up of what output you're trying to accomplish would help. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.