View Single Post
  #3  
Old May 26th, 2021, 03:06 PM
DSweet's Avatar
DSweet DSweet is offline
Senior Contributor
 
Join Date: Sep 2008
Location: Oberlin, Ohio
Posts: 253
Default Re: Imposition Question

Has this changed over the several iterations of FusionPro and it's Imposition programming since 2017?

Asking because I have to do a job that MUST be run as a saddle stitch job with a 1/4" gutter down the middle. I know that I can design each of the booklet pages with an extra 1/4" alternating along each side to accomplish that but I would like to be able to do that just in the imposition. If that spacing needs to change to 1/8" or to 3/8" or something else besides the 1/4" then the entire job has to be scrapped and started again from the artwork design phase.
__________________
David A. Sweet
Variable Data Specialist
HKM Direct Market Communications
Windows 7, Acrobat 10.x
FusionPro Desktop and Server 10.0.26
Reply With Quote