add 2 pages after being composed

[Bmason1825]

I have a 50-up label job that I need to add 2  pages of the blank label to each pdf created.

Is there a way to do that in Fusion Pro?

[Dan Korn]

You mean two entire blank imposed sheets (the front and back of a duplexed sheet)?  That would be a slip sheet, which you can set up on the Imposition tab of the Composition Settings dialog.  This will insert the slip sheet at the end of each imposed stack.

[Bmason1825]

No not a slip sheet.  I need to add 2 full sheets of labels at the end of pdf.  It creates a pdf by store number. So each store will vary with the number of labels some could have 2 pages of labels some 3 etc.  I need to add 2 full pages of labels at the end of each store.

[Dan Korn]

You can always repeat the last record, by setting FusionPro.Composition.repeatRecordCount in OnRecordStart.

Note again that these are imposed sheets you're adding.  In this workflow, a page is an individual coupon.