coreyd Posted December 18, 2009 Share Posted December 18, 2009 I have a client that needs OMR Marks on their piece to be read by an intelligent inserter. Any ideas on where I get these OMR marks? Link to comment Share on other sites More sharing options...
david.young Posted January 11, 2010 Share Posted January 11, 2010 We use OMR marks on an accumulator, should be the same for your inserter. All it is is a half inch long 1pt rule placed in the read zone in one or several positions. The manufacturer should provide you with a table of how they need to be setup. There will be different combinations for which pockets you need to pull from or not. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.