Jump to content

Mailstar

Registered Users - Approved
  • Posts

    4
  • Joined

Converted

  • FusionPro Products
    No

Mailstar's Achievements

Newbie

Newbie (1/14)

  • First Post Rare
  • Week One Done
  • One Month Later
  • One Year In
  • Conversation Starter Rare

Recent Badges

10

Reputation

  1. I am also having a similar issue where the ppml file drops bleeds and then shifts the crop marks about a 1/4 inch. The strange thing is, this doesn't always occur. Are there any properties in the file that would cause something like this? We usually end up using pdfs because of this. We are getting close to busy season and we need to know asap. Thanks! Fusion Pro: 9.3.15 Printer: Ricoh 9110
  2. The Gotham family doesn't "allow" bolding or italicizing, you have to call out the specific flavor of the font. Instead of <b>T</b> try: <f name=Gotham Bold>T<f name=Gotham Book> Depending on how your rule is written you might need to write it like the following: + '<f name = "Gotham Bold">T</f>' +
  3. With your bleeds set to 1/8", In Imposer, under the Step and Repeat section, if you set your spacing to 0, you'll get the two bleeds abutting, which gives you the 1/4" that doesn't allow the crop marks to print in your 19" of available space. If you set spacing to -.06 you'll wind up with a 3/16" gutter, but Imposer overlaps one card over the next. So, one card will have 1/8" but the other only 1/16". If you set spacing to -.125 you'll wind up with the 1/8" spacing you're looking for, but it will only work if your bleeds match, as one card will have no bleeds at all along the bottom edge, as it will be overlapped by the succeeding card. I usually use the -.06 for 6x11 full bleed cards, you just have to watch your alignment off the printer.
  4. EDIT: Please DO NOT attach proprietary fonts to this public forum! Thanks! - Dan Korn I'm having trouble with a font not loading, called Whitman. I can use the font in every other program on my computer, but not FusionPro. I've installed, uninstalled, installed again, loaded several times. Activated and deactivated the font. Restarted both the computer and the programs and still nothing. When looking into the fonts.ini and fonts.err the font is not listed in either. How can I get this font installed for use with my customer's job? Mac OSX 10.10.3 Acrobat PRO 11.0.10 FusionPro 9.3.15
×
×
  • Create New...