rdomaschuk Posted September 11, 2008 Share Posted September 11, 2008 Here's a little trick that I've mentioned in the past and, now that we have a forum that you can search in, I want to post it again. This is a great little tip if you want to use a graphic image that has less than 100% opacity. Create your image in Illustrator and set the opacity to the level you want. Then, in Illustrator, go to Fil > Save As... and save it as an Illustrator PDF. Make sure you select the "Maintain Illustrator Editing Data" (or whatever it's called) and save the PDF. Use that PDF as an image in your FusionPro template and, voila, you have a translucent image. Link to comment Share on other sites More sharing options...
Ryan Graybeal Posted February 11, 2009 Share Posted February 11, 2009 This saved my butt. Thanks Rob. Link to comment Share on other sites More sharing options...
mclisa81 Posted February 12, 2009 Share Posted February 12, 2009 Hi Rob, I found your post today and thought it was what I was looking for, but not quite. I have an image that needs to be used at 100% opacity at the top of my template, and at the bottom I need to use it at an opacity of 20% of the original. Is there a way to do this in fp utilizing only 1 image? Or would I need 2 separate ones? Thanks Lisa Link to comment Share on other sites More sharing options...
mhilger Posted February 12, 2009 Share Posted February 12, 2009 Hello Lisa, There is no capability to provide for variable opacity of images in FusionPro at this time so I would go the 2 images route. Link to comment Share on other sites More sharing options...
mclisa81 Posted February 12, 2009 Share Posted February 12, 2009 That's what I was afraid of, thanks Mark Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.